Chapter 4. Unpacking and Site Preparation
8004708 Cellometer™ Ascend User Manual Rev A 16
SITE PREPARATION
Facility Requirements
Instrument must be plugged directly into a surge protector (recommended) or power outlet. Ensure all cables are
free from kinks or tangles prior to starting the Cellometer Ascend.
Due to how the instrument is used with liquids, the instrument should be placed on a level surface.
Keep the area around the Cellometer Ascend clean between, during and post operation.
Electrical requirements for the Cellometer Ascend are as follows:
• 1.5 AMP service
• Wall receptacle voltage between 100 to 240 VAC
• 50/60 Hz
Note: Voltage requirements vary per region. For international customers, ensure that Power Cord meets local
regulations or use a suitable replacement.
Note: The instrument can be disconnected from the mains by disconnecting the Power Cord from the mains plug
or appliance coupler.
CAUTION: Do not position the device so that it is difficult to disconnect from the power main.
Transporting the Instrument
Prior to transporting the instrument by vehicle, disconnect the main from the wall and package all accessories and
consumables individually and safely, ensuring cables are also protectively wrapped. Refer to instrument
dimensions to ensure vehicle to be used for transporting meets these requirements.
When the instrument is loaded into the vehicle, it should be secured in such a way to prevent the instrument or
components from shifting during transport.
WARNING: Care should be taken while moving or transporting the instrument to prevent
damage to the instrument and/or possible injury.
Disposal of Waste Electrical and Electronic Equipment
To comply with European Commission Directive on Waste Electrical and Electronic Equipment
(WEEE) and other country and state regulations, do not dispose of this equipment in any location
other than designated waste locations. For information regarding proper product disposal,
contact Support by visiting https://www.revvity.com/contact-us or send an email to:
CellC-support@revvity.com
To Next Page