REXROTH efc series - Installing the Card in Frequency Converter; Cables

3.2 Installing the Card in Frequency Converter
The MEP extension card must be installed in combination with the extension
card module in the EFCx610 frequency converter. For details, please refer to Ex-
tension Card Module Mounting Instructions.
CAUTION
The MEP extension card does not support hot plug.
3.3 Cables
At least CAT 5e standard Ethernet cable is required for data transmission. The
shielded cables are recommended for the use in industrial environments.
The transmission rate is fixed at 100 Mbps.
Bosch Rexroth AG
Hardware Installation
Multi-Ethernet Card
6/61
DOK-RCON0*-XFCX610*MUL-IT02-EN-P