3.4 LEDs
Two slots are provided in the extension card module. On each slot, four dual-col-
or LEDs are equipped for state indication if the MEP extension card is applied.
The network status (NS: H11/H21) and module status (MS: H12/H22) LEDs are
red/green. The physical status of port 1 (P1: H13/H23) and port 2 (P2: H14/
H24) are yellow/green.
The figure below shows an overview of LED indications on the extension card.
Fig. 3-2: Multi-Ethernet card LED
The LED functionality is described in chapter 11.
3.5
Power Supply
Please make sure the main circuit power supplied during commissioning and
firmware update. External 24 V will keep the basic communication when main
power loss, but only limited parameter access and no run possible.
Multi-Ethernet Card
Bosch Rexroth AG
Hardware Installation
DOK-RCON0*-XFCX610*MUL-IT02-EN-P
7/61
To Next Page
Loading...
