7 SERCOS III
7.1 Protocol Configuration
After the SERCOS III protocol is activated (H3.41 = S3), the unique device ad-
dress in the SERCOS III network must be set via parameter H3.23.
Fig. 7-1: Device address setting
Or the SERCOS address can be assigned within project from automatically cal-
culated topology index. The resulted address reflects in parameter H3.24.
Multi-Ethernet Card Bosch Rexroth AG
SERCOS III
DOK-RCON0*-XFCX610*MUL-IT02-EN-P
31/61
To Next Page
Loading...
