• Be careful not to trap your fingers.
• Up to two paper feed units can be attached.
• To install two paper feed units, put the upper paper feed unit (tray 2) on the lower paper feed tray
(tray 3) first, and then lower the printer onto the upper paper feed unit (tray 2).
• For details about registering where to start printing on paper loaded in the paper feed unit, see
p.170 "Registration".
Attaching the Multi Bypass Tray BY1000
1. Make sure the printer's power cord is unplugged.
2. Take the bypass tray out of its box.
3. Remove the orange tape from the bypass tray.
4. Fully insert the bypass tray.
5. When using the bypass tray, pull out its extension and adjust the side guides according to
the size of the loaded paper.
After
attaching the paper feed unit, you must register where to start printing on paper loaded in the paper
feed unit.
• For details about registering where to start printing on paper loaded in the paper feed unit, see
p.170 "Registration".
Installing the Print Cartridges
• If
ink comes into contact with your eyes, rinse immediately in running water. For other symptoms,
consult a doctor.
2. Preparing for Printing
40
To Next Page
Loading...
