6. Press the [ ] or [ ] key to enter the left most entry field of the IP address, and then press the
[#Enter] key.
IP Address:
. 0. 0. 0
To get an IP address for the printer, contact your network administrator.
The value moves by 10 if the [ ] or [ ] key is kept pressed.
When the [#Enter] key is pressed, the cursor moves to the next field.
7. Press the [#Enter] key.
As the specified value is entered in each field, the cursor moves to the next field.
IP Address:
192. . 0. 0
8. Repeating the steps, specify values in all fields, and then press the [#Enter] key.
To return to the previous field, press the [Escape] key.
9. Specify "Subnet Mask" and "Gateway Address" in the same way as when specifying the IP
address.
10. After you have made all the settings, press the [Online] key.
The specified settings are set and the initial printer screen reappears.
You can print the configuration page to confirm the specified settings.
• For details about how to print a configuration page, see p.54 "Printing a Configuration Page".
Quick Install for Network
Follow the procedure below to install the printer driver, User Guide, and DeskTopBinder -
SmartDeviceMonitor for Client.
• If the version of SmartDeviceMonitor for Client already installed in the computer is newer than that
on the CD-ROM, you cannot use "Quick Install" to install the printer driver. Install the printer driver,
and then create the port.
•
Only administrators can perform this installation. Log on as a member of the Administrators group.
Notes on the Installation (Network Connection)
If the message "Digital Signature Not Found" or the [Software Installation], [Hardware Installation]
or [Windows can't verify the publisher of this driver software] dialog box appears:
1. Click [Yes], [Continue Anyway] or [Install this driver software anyway] to continue the installation.
Connecting the Computer and Installing the Software (Network Connection)
63
To Next Page
Loading...
