The surface should be level within two degrees.
Make sure the power cord is not trapped under the printer.
4. Press the [Power] key.
The printer starts feeding ink into its print heads (taking approximately 6 minutes).
Make sure the "Ready" message is displayed on the control panel.
Do not switch off the power of the machine during this period. Make sure the plug is not removed
from the wall outlet.
You might hear a clicking sound while the print heads are filling. This is not a malfunction. It will stop
after a while.
Loading Paper
Load paper into the paper tray.
Normally, load paper into tray 1.
• Load paper with the paper grain parallel to the feed direction.
Setting Up the Hardware
45
To Next Page
Loading...
