3. Remove the seal on the USB slot located on the rear of the printer, and then insert the USB
cable's hexagonal (type B) plug firmly into the slot.
4. Insert the USB cable's rectangular (type A) plug firmly into the computer's USB slot.
• Insert the USB cable's plug with the USB mark facing down.
•
Make sure that the USB cable is fully inserted.
• Make sure the USB cable is connected properly, especially when the bypass tray is attached to the
printer, because the tray makes connecting the cable difficult.
Quick Install for USB
Follow the procedure below to install the printer driver and User Guide.
• Do not turn the printer on until you have read how to do so.
• Only administrators can perform this installation. Log on as a member of the Administrators group.
2. Preparing for Printing
54
To Next Page
Loading...
