Plugging in the Power Cord and Turning the Power On
Before connecting the printer to a computer, connect the printer's power cord and switch the printer on.
• Only connect the machine to the power source described on this sheet.
•
Avoid multi-wiring.
• Connect the power cord directly into a wall outlet and never use an extension cord.
• Do not use power cords that are damaged, broken, or modified. Also, do not use power cords
that have been trapped under heavy objects, pulled hard, or bent severely. Doing so could result
in fire or electric shock.
• Do not plug or unplug the power cord with your hands wet. Otherwise, an electric shock might
occur.
• Do not handle the machine while the cartridge is being filled. Ink filling begins when the machine's
power is switched on. Until the "Loading Ink..." message disappears from the control panel.
1. Remove the orange tape from around the power cord.
2. Plug the power cord fully into the printer.
To Next Page
Loading...
