1. Indicator (green)
Remains
green as long as the machine is properly connected to the network via 100 BASE-TX cable. Unlit
if 10 BASE-T cable is connected.
2. Indicator (orange)
Lights whenever the printer is sending or receiving data via the network.
3. [Reset] key
Press this to initialize and reboot the network interface board.
Specifying Settings on the Control Panel
Make the following network settings according to the network interface you are using.
If you have connected the printer to a network, make the required network environment settings.
The following table shows the control panel settings and their default values. These items appear in the
[Network Setup] menu.
Setting Name Value
1.DHCP On
2.IP Address 0.0.0.0
3.Subnet Mask 0.0.0.0
4.Gateway Address 0.0.0.0
5.Active Protocol TCP/IP: Active
6.Ethernet Speed Auto Select
The following example explains making settings for TCP/IP.
Connecting the Computer and Installing the Software (Network Connection)
61
To Next Page
Loading...
