Setting Up a Client Computer
Follow the procedure below to configure a computer as a client computer and connect it to the shared
printer. Make this setting when installing the printer driver from the CD-ROM provided.
• Only administrators can make this setting. Log on as a member of the Administrators group.
Configure a computer connected to the network where the print server is connected.
1. Start Windows, and then insert the "Printer Drivers, Manuals, Utilities" CD-ROM into the
CD-ROM drive.
Quit all other applications currently running.
When
starting Windows, a wizard for adding new hardware may open. If this happens, click [Cancel].
Check again that the power is off.
2. Select a language for the interface, and then click [OK].
3. Click [PCL/RPCS Raster Printer Drivers].
4. Read the entire license agreement carefully. If you accept its terms, click [I accept the
agreement.], and then click [Next >].
5. Click [Connected via LAN].
6. Click [Next >].
7. Click the plus mark next to a printer name.
8. Click [Port:< LPT1: >] under [Printer name:].
9. Click [Add].
10. Click [Network Printer].
11. Click [OK].
12. Select a shared printer.
13. Click [OK].
14. Check that [<\\servername\sharedprintername>] appears after [Port:].
15. Click [Finish].
Installation starts.
16. Select whether or not to open the Status monitor automatically.
17. Click [Next >].
18. Check the installation result, and then click [Finish].
• When
the CD-ROM is inserted, the [Printer Drivers, Manuals, Utilities] dialog box appears. If it does
not, double-click the CD-ROM drive icon under [My Computer] or [Explorer], and then double-click
[SETUP.EXE].
Installing the PCL or RPCS Raster Printer Driver (USB)
71
To Next Page
Loading...
