• Ink smearing can be caused by environmental conditions (such as high humidity) and the type
of image being printed (such as ink-heavy images). If smearing occurs, set [Print Quality] to
[Quality priority] or [Speed priority]. This may stop the ink smearing.
• Roller marks might appear on printed images.
• If paper is fed from the bypass tray, roller marks might appear on the printed image.
• To ensure water and oil resistance, leave the printed sheet to dry for about a day.
• Some print images can cause the paper to curl, which creates patchy print. If this happens, set
[Print Quality] to [Quality priority].
• When using these sheets, see the instructions supplied with them.
• Duplex printing is not supported.
Envelopes
• Up to 20 envelopes can be loaded in tray 1.
• Flatten envelopes.
• Load envelopes carefully, because the printable area depends on the orientation.
• Set the envelope selector to the rear position before printing.
• Duplex printing is not supported.
Thick paper
• Thick paper is heavier than 157 g/m
2
(42 lb.).
• You can insert paper with weights up to 255 g/m
2
(60 lb.) into the bypass tray.
• Insert paper with the print side face up into the bypass tray.
• Duplex printing is not supported.
Cautions to Observe After Printing
Depending on the paper type, the ink may take a while to dry. Before handling, make sure printed
sheets have fully dried. Otherwise, the ink may smudge.
• The ink may smear depending on the type of image. If this happens, set the envelope selector to the
rear position .
Non-compatible Paper
Check if the paper is compatible.
Do not use paper that is:
•
wrinkled, folded, or damaged
• wavy at the ends
• curled
Paper
91
To Next Page
Loading...
