3. Press the [ ] or [ ] key to display [De-condensation], and then press the [#Enter] key.
Maintenance:
De-condensation
Three sheets are fed through the printer without anything being printed on them.
4. Switch the printer off and then back on again.
If the error message does not reappear, the printer's interior has fully dried.
If the error persists, switch the printer off, leave it for an hour, and switch it back on. If this does not
solve the problem, contact your sales or service representative.
• If the paper is smeared with ink after being ejected, contact your sales or service representative.
• p.316 "Where to Inquire"
Performing Maintenance using the Control Panel (Maintenance Menu)
177
To Next Page
Loading...
