Envelopes
• Up to 20 envelopes can be loaded in tray 1.
• Flatten envelopes.
• Load envelopes carefully, because the printable area depends on the orientation.
• Set the envelope selector to the rear position before printing.
• Duplex printing is not supported.
Thick paper
• Thick paper is heavier than 157 g/m
2
(42 lb.).
• You can insert paper with weights up to 255 g/m
2
(60 lb.) into the bypass tray.
• Insert paper with the print side face up into the bypass tray.
• Duplex printing is not supported.
Cautions to Observe After Printing
Depending on the paper type, the ink may take a while to dry. Before handling, make sure printed
sheets have fully dried. Otherwise, the ink may smudge.
• The ink may smear depending on the type of image. If this happens, set the envelope selector to the
rear position .
Non-compatible Paper
Check if the paper is compatible.
Do not use paper that is:
•
wrinkled, folded, or damaged
• wavy at the ends
• curled
• absorbent
• dry and conducive to static buildup
• already printed on (such as the back of pre-printed paper)
• pre-printed (unless specified)
• heat sensitive/non-carbon
• too thick or thin
• pre-stitched
• glued or tacked
• stapled or clipped together
Paper
89
To Next Page
Loading...
