4012 1 Leading edge
[0 to 9.0 / 1.0 / 0.1 mm/step]
4012 2 Trailing edge
4012 3 Left
4012 4 Right
4013 Scanner Free Run
4013 1
Performs a scanner free run with the exposure lamp on. Press ON or to start. Press OFF to
stop.
4015* White Plate Scanning
4015 1
Start position [–3.0 to +6.0 / 0.0 / 0.1 mm/step]
Adjusts the scanning start position on the white plate for auto shading. The base value
stored
in
the
machine is 15.2 mm toward the white plate from the scanner HP. This SP setting
specifies the offset from this base value.
4015 2
Scanning length [–3.0 to +6.0 / 0.0 / 0.1 mm/step]
Adjusts the length of the white plate scan, in the main scan direction. The scan begins at
the start position
set above [in SP 4015 1] and extends for the specified length. The base
value stored in the machine is 4.76 mm. This SP setting specifies the offset from this base
value.
4301 Display-APS Data
4301 1
Displays the status of the APS sensors and platen/DF cover sensor ( ADF APS Sensor
Output Display (SP 6901)).
4303* APS Small Size Original [0 = No (not detected) / 1 = Yes (A5/HLT LEF)]
4303 1
Selects whether or not the copier will consider the original to be A5/HLT LEF when the APS
sensors cannot detect its size. If "Yes" is selected, paper sizes that cannot be detected by
the APS sensors
are regarded as A5/HLT LEF. If "No" is selected, "Cannot detect original
size" will be displayed.
4305* APS Priority [0 = Normal / 1 = A4/LT / 2 = 8K/16K]
3. Appendix: SP Mode Tables
32
To Next Page
Loading...
