By-pass Tray
1. Right rear cover (above)
2. Open the right door.
3. Release
the by-pass tray cable from the clamps (see [B] on the preceding procedure) and disconnect
the connector (5-pin connector with colored wires).
4. Cable holder [A] (B244/B269/B277 only)
5. Front-side clip ring [B]
6. Front-side pin [C] (You can push the pin from behind the right door.)
7. Front-side tray holder arm [D]
8. Remove the rear-side clip ring, pin, and tray holder arm in the same manner.
9. By-pass tray [E]
4. Replacement and Adjustment
82
To Next Page
Loading...
