7. Install the two brackets [E]. (1 stepped screw each).
8. Connect the connecting harness [F] to the copier.
• There are cutouts for the plugs on both sides. The left side has one cutout, and the right side has
two.
9. Reinstall the cover removed in step 2.
10.
Load the paper in the paper tray and make full size copies from tray. Check if the side-to-side and
leading edge registrations are correct. If they are not, adjust the registrations (
p.141 "Copy
Adjustments Printing/Scanning").
One-tray Paper Tray Unit Installation
45
To Next Page
Loading...
