Error Codes
D418 32 SM
Code Meaning Suggested Cause/Action
2-23
JBIG compression or
reconstruction error
Turn off the machine, then turn it back on.
Replace the EXFUNC board if the error is
frequent.
2-24 JBIG ASIC error
Turn off the machine, then turn it back on.
Replace the EXFUNC board if the error is
frequent.
2-25
JBIG data reconstruction
error (BIH error)
2-26
JBIG data reconstruction
error (Float marker error)
2-27
JBIG data reconstruction
error (End marker error)
2-28
JBIG data reconstruction
error (Timeout)
JBIG data error
Check the sender’s JBIG function.
Update the MBU ROM.
2-29
JBIG trailing edge maker
error
FCU defective
Check the destination device.
2-50
The machine resets itself
for a fatal FCU system
error
If this is frequent, update the ROM, or replace
the FCU.
2-51
The machine resets itself
because of a fatal
communication error
If this is frequent, update the ROM, or replace
the FCU.
2-53
Snd msg() in the manual
task is an error because
the mailbox for the
operation task is full.
The user did the same operation many times,
and this gave too much load to the machine.
4-01 Line current was cut
Check the line connector.
Check the connection between FCU and NCU.
Check for line problems.
To Next Page
Loading...
Need help?
General