Error Code Cause Solution
I0104-000 Failed to decrypt password. 1. A password error occurred.
Make sure the password is entered
correctly.
2. Either [DES] or [AES] is selected
for "Driver Encryption
Key:Encryption Strength".
The administrator has restricted use
of simple encryption. You can use
the encryption key if it has been
specified in the driver.
3. A driver encryption key error
occurred.
Make sure that the encryption key is
correctly specified on the driver.
I0105-000 A login user name was not specified
but a DeskTopBinder operation was
performed.
Set the DeskTopBinder login user
name correctly.
I0206-002 A user attempted authentication from
an application on the "System
Settings" screen, where only the
administrator has authentication
ability.
Only the administrator has login
privileges on this screen.
Log in as a general user from the
application's login screen.
I0206-003 An authentication error occurred
because the user name contains a
space, colon (:), or quotation mark
(").
Recreate the account if the account
name contains any of these
prohibited characters.
If the account name was entered
incorrectly, enter it correctly and log
in again.
I0207-001 An authentication error occurred
because the Address Book is being
used at another location.
Wait a few minutes and then try
again.
If Authentication Fails
293
To Next Page
Loading...
Need help?
General
