Message Problem and solutions
Name registration success in Broadcast
name=<NetBIOS name>
Name registration by <NetBIOS Name>
broadcast was successful.
Name registration success. WINS server=<WINS
server address> NetBIOS Name=<NetBIOS
name>
Name registration of <NetBIOS Name> to <WINS
server address> was successful.
nbtd start. The nbtd (NetBIOS over TCP/IP Daemon) has
started.
npriter start. (NetWare) (In the remote printer mode) The NetWare service
has started.
no RADIUS/authentication server The supplicant has received a message reporting
that a usable RADIUS server cannot be found.
no smart card detected on device PEAP/GTC (Generic Token Card) is selected, but
a smart card using GTC authentication cannot be
found.
no SSID in scan result A network with the SSID you specified was not
found.
The specified SSID might not be available, or the
signal from the access point/multi-channel might
be weak.
no WPA information element in probe response,
rescanning
There is no WPA information on the response from
the SSID probe of the access point you want to use.
The supplicant is rescanning.
nwstart start. (NetWare) The NetWare protocol stack setup server has
started.
Open log file <file name> The specified log file was opened when the print
server was online.
permission denied. When canceling a job, it was determined after
checking the user name and host address that the
user's privileges were insufficient. (Does not apply
to root privileges.)
4. Monitoring and Configuring the Machine
192
To Next Page
Loading...
