Stop/Clear Key
Enables and disables fax RX stop by pressing [Stop/Clear].
• Not Functional. (Default) Pressing [Stop/Clear] has no
effect on the fax transmission being received.
• Functional. Pressing [Stop/Clear] cancels the fax
transmission being received. Pressing the key after the fax
has started print has no effect.
TX Settings
Redial Interval
Sets the time interval being redialing attempts if a TX fails.
•
Default: 5 min.
•
Range: 5 min. or 6 min.
Redialings
Sets the number of redial attempts if a TX fails.
• Default: 3 Times
• Range: 2, 3, 4, or 5 Times
Overseas Comm Mode Settings
Overseas Comm Mode
Sets the machine to ignore a DIS (Digital Identification Signal)
sent from a called station. This setting determines whether the
machine waits the echo canceller to stop after the CED/ANSam
signal is sent. To wait means to ignore the first DIS and wait until
the echo canceller that responds stops and restarts.
• Off (Default)
•
Ignore DIS Once
Minimum Time Length
If Overseas Comm Mode is "Off" the machine detects the CNG
signal as long as the line is connected. If set to "On" the machine
detects the CNG signal after the line is connected.
• Default: 350 ms
• Range: 100 to 400 ms
Dial Pulse Setting
6. Troubleshooting
192
To Next Page
Loading...
