Timeout Length
Sets the length of the time-out for the 1st dial tone
connection. The machine waits the time specified
below for a dial tone, and then disconnects
automatically if no dial tone is detected.]
• Default: 10 sec.
•
10 to 30 sec.
BT (Busy Tone) Detecton
BT Setting
Sets busy tone detection.
• On (Default)
•
Off
Comm Settings
RTN Rate
Sets the error ratio for error judgment on data
received in non-ECM mode.
• Default: 11%
•
Range: 11% or 14%
V34 Modem
A V34 modem cannot operate if use of a V34
modem is prohibited with the setting below.
Therefore, if 33.6 is selected for the TX/RX Speed
setting in the User Tool V17 must be selected.
• Permitted. (Default) Use of V34 modem is
allowed.
• Prohibited. Use of V34 modem not allowed.
V17 Modem
A V17 modem cannot operate if use of a V17
modem is prohibited with the setting below.
Therefore, if 14.4 is selected for the TX/RX Speed
setting in the User Tool V29 must be selected.
• Permitted. (Default) Use of V34 modem is
allowed.
• Prohibited. Use of V34 modem not allowed.
V34 Settings
6. Troubleshooting
194
To Next Page
Loading...
