Message Problem and solutions
add_sess_IPv6: community <community name> al-
ready defined.
The same community name already exists. Use an-
other community name.
add_sess_IPX: bad trap<IPX address>community
<community name>
The IPX address (00:00:00:00:00:00) is unavail-
able when the community access type is TRAP.
Specify the host IPX address for the TRAP destina-
tion.
add_sess_IPX: community <community name> al-
ready defined.
The same community name already exists. Use an-
other community name.
Attach FileServer= <file server name> Connection to the file server as the nearest server
has been established.
Attach to print queue <print queue name> (In the print server mode) Attached to the print
queue.
Authentication mode mismatch< SSID > Authentication mode is different to the AP. The re-
quired SSID is the SSID of the access point con-
nected to when in infrastructure mode.
btd is disabled. Communication via Bluetooth is unavailable be-
cause btd is disabled in the security mode. Enable
the btd in the security mode.
centrod is disabled. Communication via parallel connections unavail-
able because centrod is disabled in the security
mode.
Enable centrod in the security mode.
Cannot create service connection (In the remote printer mode) Connection to the file
server has not been established. The number of file
server users may have exceeded the maximum ca-
pacity of the file server.
Cannot find
rprinter (<print
server name>/<printer
number>)
The printer with the number displayed on the print
server does not exist. Make sure that the printer
number is registered on the print server.
Change IP address from DHCP Server. The IP address changes when DHCP lease is re-
newed. To always assign the same IP address, set
a static IP address to the DHCP server.
6. Monitoring and Configuring the Printer
282
To Next Page
Loading...
Need help?
General