Message Problem and solutions
child process exec error! (process name) The network service failed to start. Turn the printer
off and then on. If this does not work, contact your
service or sales representative.
Client password rejected The client's password was rejected. Check the client
password.
Client tls certificate rejected The client's TLS certificate was rejected. Check the
certificate.
Connected DHCP Server(<DHCP serveraddress>). The IP address was successfully received from the
DHCP server.
Could not attach to FileServer<error number> (In the remote printer mode) Connection to the file
server has not been established. The file server has
refused the connection. Check the file server con-
figuration.
Could not attach to PServer<print server> (In the remote printermode) Connection to the print
server has not been established. The print server
has refused the connection. Check the print server
configuration.
Current Interface Speed: xxxMbps Speed of the network (10Mbps, 100 Mbps, or
1Gbps).
Current IP address <current IP address> Current IPv4 address.
Current IPX address<IPX address> Current IPX address
DHCP lease time expired. DHCP lease time has expired. The printer tries to
discover the DHCP server again. The IP address
until now becomes invalid.
DHCP server not found. The DHCP server was not found. Make sure that the
DHCP is on the network.
dhcpcd start The DHCPCD service (dhcp client service) has start-
ed.
dpsd is disabled. Communication via PictBridge is unavailable be-
cause PictBridge is disabled in the security mode.
Enable PictBridge in the security mode.
Message List
283
To Next Page
Loading...
Need help?
General