Ricoh Aficio SP C811DN User Manual

Message Problem and solutions
Login to fileserver <file server name> (<IPX|IPv4|
IPv6>,<NDS|BINDERY>)
(In the print server mode) Login to the file server is
in the NDS or BINDERY mode.
Memory allocate error. Data cannot be obtained.
Disconnect the USB cable, and then connect it.
Name registration success. WINS Server=<WINS
server address> NetBIOS Name=<NetBIOS
name>
Name registration of <NetBIOS Name> to <WINS
server address> was successful.
Name registration success in Broadcast
name=<NetBIOS Name>
Name registration by Broadcast name of <Net-
BIOS Name> was successful.
Name registration failed. name=<NetBIOS name> Name registration of <NetBIOSName> failed.
Change to different NetBIOS name.
nbtd start. The nbtd service has started.
nprinter start (Netware) (In the remote printer mode) The NetWare service
has started.
nwstart start. (NetWare) The service for NetWare protocol stack setting has
started.
Open log file <file name> (In the print server mode) The specified log file has
been opened.
phy release file open failed. Replacing the network interface board is required.
Contact your sales or service representative.
Print queue <print queue name> cannot be serviced
by printer 0, <print server name>
(In the print server mode) The print queue cannot
be established. Make sure that print queue exists
on the specified file server.
Print server <print server name>has no printer. (In the print server mode) The printer is not assigned
to the print server. Using NWadmin, assign the
printer, and then restart it.
print session full No more print jobs can be accepted.
Printer <printer name> has no queue (In the print server mode) The print queue is not
assigned to the printer. Using NWadmin, assign the
print queue to the printer, and then restart it.
Message List
285
6

Ricoh Aficio SP C811DN Specifications

General

Brand	Ricoh
Model	Aficio SP C811DN
Category	Printer
Language	English