Ricoh D037 - Page 14

D037/D038/D040/D041 ii SM
Settings Relevant to the Service Contract ..........................................2-15
Settings for @Remote Service............................................................2-16
2.3.5 MOVING THE MACHINE ................................................................2-19
2.3.6 TRANSPORTING THE MACHINE ..................................................2-20
Main Frame.........................................................................................2-20
2.4 PAPER FEED UNIT (D331)......................................................................2-21
2.4.1 ACCESSORY CHECK ....................................................................2-21
2.4.2 INSTALLATION PROCEDURE .......................................................2-21
2.5 PAPER FEED UNIT (D425)......................................................................2-24
2.5.1 COMPONENT CHECK....................................................................2-24
2.5.2 INSTALLATION PROCEDURE .......................................................2-24
2.6 CASTER TABLE (D488)...........................................................................2-27
2.6.1 COMPONENT CHECK....................................................................2-27
2.6.2 INSTALLATION PROCEDURE .......................................................2-27
2.7 ARDF (D366)............................................................................................2-29
2.7.1 COMPONENT CHECK....................................................................2-29
2.7.2 INSTALLATION PROCEDURE .......................................................2-29
2.8 PLATEN COVER INSTALLATION (G329) ...............................................2-33
2.9 SIDE TRAY (D427)...................................................................................2-34
2.9.1 COMPONENT CHECK....................................................................2-34
2.9.2 INSTALLATION PROCEDURE .......................................................2-34
2.10 1-BIN TRAY UNIT (D426)...................................................................2-37
2.10.1 COMPONENT CHECK ..............................................................2-37
2.10.2 INSTALLATION PROCEDURE..................................................2-37
2.11 SHIFT TRAY UNIT (D428)..................................................................2-40
2.11.1 COMPONENT CHECK ..............................................................2-40
2.11.2 INSTALLATION PROCEDURE..................................................2-40
2.12 INTERNAL FINISHER (D429).............................................................2-42
2.12.1 COMPONENT CHECK ..............................................................2-42
2.12.2 INSTALLATION PROCEDURE..................................................2-43
Preparing before Installing the Internal Finisher..................................2-43
Internal Finisher Installation ................................................................2-45
2.13 PUNCH UNIT (D390)..........................................................................2-48
2.13.1 COMPONENT CHECK ..............................................................2-48
2.13.2 INSTALLATION PROCEDURE..................................................2-48
Removing the Internal Finisher ...........................................................2-49
Preparing the Punch Unit before Installing the Internal Finisher .........2-51