SERVICE PROGRAM MODE
SM 5-1 G104
Service
Tables
5. SERVICE TABLES
5.1 SERVICE PROGRAM MODE
CAUTION
Before accessing the service menu, do the following:
Confirm that there is no print data in the printer buffer (the Data In LED
must not be lit or blinking).
If there is some data in the buffer, wait until all data has been printed.
5.1.1 SERVICE MODE OPERATION
NOTE: The Service Program Mode is for use by technical professionals only, so
that they can properly maintain product quality. If this mode is used by
anyone other than the technical professional for any reason, data might be
deleted or settings might be changed. In such case, product quality cannot
be guaranteed.
Entering the Service Mode
There are two ways to enter the service mode.
Method 1: Turn the machine on while pressing the “On Line” key and “Escape” key
together until “SYSTEMver x.xx/ 1. Service” shows on the display.
NOTE: If you switch the machine off, any jobs stored on the hard disk using the
sample print and protected print features will be deleted.
Check first with the user tools to see if there are any jobs stored with these
features (Menu key - Sample Print, or Protected Print). If so, you may use
method 2 to enter service mode.
Method 2: Press the “Up/Down arrow” keys together for about 5 seconds, then
press the “Enter” key.
The “SYSTEMver x.xx/ 1. Service” appears on the display.
NOTE: The machine automatically goes off line when you enter the service mode.
Enter
Escape
Menu
Online
From Feed
Job Reset
Power
Alert
Data In
G105S902.WMF
To Next Page
Loading...
Need help?
General
