FIRMWARE UPDATE
SM 5-103 G104
Service
Tables
13. To start firmware update, push the enter key. While each firmware is
downloaded, the underscores on the operation panel are replaced by stars.
14. Wait until the message “Updated” is shown.
15. Turn off the main power switch.
16. Remove the SD card from the slot.
17. Attach the slot cover ( x 1).
18. Connect the printer to the network physically.
19. Turn on the main power switch.
20. Print the Configuration Page to check that the every firmware is correctly
updated: Menu > List/Test Print > Config.P/Er.Log
Error Handling
An error code is shown if an error occurs during the download. Error codes have
the letter “E” and a number. If an error occurs, the firmware has not correctly
downloaded; see the error code table (5.3.6) and perform the necessary steps.
After this, try to download the firmware again.
Power Failure
If firmware update is interrupted by power failure, the firmware has not correctly
downloaded. In this case, machine operation is not guaranteed. You have to
download the firmware again.
To Next Page
Loading...
