Fusing
SM 6-23 G160/G161
G160/G161
6.6.3 DRIVE
After the toner image is transferred to the paper [A], it goes through the fusing unit. The
fusing unit contains the heating roller [B]. The heating lamp [C] applies heat to the heat
roller. The heat roller applies heat to the fusing belt [D] to melt the toner on the paper. The
paper receives pressure between the fusing belt and the pressure roller [E], and melted
toner bonds to the paper.
When the paper goes out of the fusing unit, it goes to the exit tray. The fusing exit sensor
[F] detects paper jams.
To Next Page
Loading...
