Service Program Mode
SM 5-1 G160/G161
G160/G161
5. SERVICE TABLES
5.1 SERVICE PROGRAM MODE
Before accessing the service menu, do the following:
1. Confirm that there is no print data in the printer buffer (the Data In
LED must not be lit or blinking).
2. If there is some data in the buffer, wait until all data has been
printed.
This machine has SSP mode, which is restricted for supervisor use only. However,
most of them are also used for the factory adjustments. Do not change those SSP
settings unless it is indicated to do so by the service manual.
5.1.1 SERVICE MODE OPERATION
The Service Program Mode is for use by service representatives only, so that they
can properly maintain product quality. If this mode is used by anyone other than
service representatives for any reason, data might be deleted or settings might be
changed. In such case, product quality cannot be guaranteed.
Entering the Service Mode
If you switch the machine off, any jobs stored on the hard disk using the sample
print or protected print features will be deleted.
Check with the user tools first to see if there are any jobs stored with these
features (Menu key - Sample Print, or Protected Print).
To Next Page
Loading...
