PAPER FEED
G104 3-14 SM
3.4.4 BY-PASS FEED ROLLER, FRICTION PAD
1. By-pass tray cover [A]
2. By-pass tray [B] ( x 2, x 1) and
the harness cover [C]
3. By-pass feed shaft cover [D]
4. Move the holding roller left [E]
5. By-pass feed roller [F]
6. By-pass friction pad [G]
1) Pull up the edge of the by-pass
friction pad ().
2) Pull the by-pass friction pad
forward. When you do this, hold
down the edge where its shaft is
located ().
Reassembling the by-pass friction pad
1. Place the spring [H] on the projection
[I] of the by-pass tray.
2. Hold down the by-pass friction pad
after you put the spring on the projection of pad’s reverse side ().
3. Release the by-pass tray friction pad when it passes through the bushing [J].
4. Pull up the shaft of the by-pass friction pad to the busing until it clicks.
G105R113.WMF
G105R114.WMF
3
3
2
1
G105R156.WMF
[G]
[H]
[I]
[J]
[A]
[B]
[C]
[D]
[E]
[F]
To Next Page
Loading...
