SD CARD APPLI MOVE
G104 5-108 SM
5.4.2 MOVE EXEC
The menu “Move Exec” (SP5873-001) enables you to copy application programs
from the original SD card to another SD card. The application programs are copied
as follows:
• From slot 3 to slot 2 when SD cards are
in slots 2 or in all slots
Note that the authentication data is also
copied with the application program (
5.4.1).
1. Turn off the main power switch.
2. Make sure that an SD card is in slot 2. The application program is copied to the
SD card in slot 2.
3. Insert the SD card (having stored the application program) to slot 3. The
application program is copied from this SD card.
4. Turn on the main power switch.
5. Start the SP mode.
6. Select SP5873-001 “Move Exec.”
7. Follow the messages displayed on the operation panel.
8. Exit the SP mode.
9. Turn off the main power switch.
10. Remove the SD card from slot 3.
11. Turn on the main power switch.
12. Check that the application programs run normally.
G105S905.WMF
1 2 3
To Next Page
Loading...
