Ricoh G104 - Electrical Components; Controller Board

Electrical Components
SM 3-9 G160/G161
G160/G161
3.4 ELECTRICAL COMPONENTS
 Before you replace the EGB (Engine Board), the controller, or the NVRAM,
print out the SMC reports (“SP Mode Data” and “Logging Data”).
 After you replace the EGB (Engine Board) or the controller, remove the
NVRAM from the old board and install it on the new board. If the NVRAM on
the old board is defective, replace the NVRAM (see ‘NVRAM Replacement
Procedure’).
3.4.1 CONTROLLER BOARD
1. Controller unit [A] (
x 3)
2. Controller unit cover [B] (
x 4)
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA