SD Card Application Move
SM 5-167 G160/G161
G160/G161
1. Turn off the main power switch.
2. Make sure that an SD card is in slot 1. The application program is copied to SD
card in slot 1.
3. Insert the SD card (having stored the application program) to slot 3. The
application program is copied from this SD card.
4. Turn on the main power switch.
5. Start the SP mode.
6. Select SP 5873-1 “Move Exec.”
7. Follow the messages displayed on the operation panel.
8. Go out of the SP mode.
9. Turn off the main power switch.
10. Remove the SD card from slot 3.
11. Turn on the main power switch.
12. Check that the application programs run normally.
5.4.3 UNDO EXEC
The program “Undo Exec” (SP 5873-2) enables you to copy application programs from an
SD card to the original SD card. You can use this program when, for example, you have
mistakenly copied some programs with Move Exec (SP 5873-1).
The application programs are copied from slot 1 to slot 3.
Note that the authentication data is also copied with the application program (see
‘Overview’).
1. Turn off the main power switch.
2. Insert the original SD card in slot 3. The application program is copied back to
this card.
3. Make sure that the SD card (having stored the application program) is in slot 1.
The application program is copied back from this SD card.
4. Turn on the main power switch.
5. Start the SP mode.
6. Select SP 5873-2 “Undo Exec.”
7. Follow the messages displayed on the operation panel.
8. Go out of the SP mode.
To Next Page
Loading...
