Service Mode Table
G160/G161 5-6 SM
5.2 SERVICE MODE TABLE
5.2.1 CONTROLLER SERVICE MODE
1001 [Bit Switch]
1001 001 Bit Switch 1 *CTL
Adjusts bit switch settings. DFU
1001 002 Bit Switch 2 *CTL
Bit 0 to 2: Not used. Do not change the settings.
Bit 3: Changing the print language (PCL <-> PS)
0: Enabled
1: Disabled (No change)
Bit 4 to 7: Not used. Do not change the settings.
1001 003 Bit Switch 3 *CTL
Bit 0: PostScript3 Euro glyph
0: Disabled
1: Enabled (Even if there is no Euro Glyph in
the ROM, it is possible to load the Euro
Glyph data.)
Bit 1: Not used. Do not change the setting.
Bit 2:PCL5e/5c (HP4000/HP8000)
The left space command is set to “0”, the
machine is changed to “1”
0: Disabled
1: Enabled
Bit 3: PCL5e/GL2: pen # of PW
0: Normal
1: Patch
Bit 4: Tray selecting
0: The tray is determined by auto tray
selection
1: Like HP/SV
Bit 5 to 7: Not used. Do not change the settings.
1001 004 Bit Switch 4 *CTL
Adjusts bit switch settings. DFU
1001 005 Bit Switch 5 *CTL
Bit 0 to 2: Not used. Do not change the settings.
Bit 3: Enables the “%%” command of the
PostScript detection condition for the auto print
language selection function.
0: Enabled
To Next Page
Loading...
