SERVICE MODE TABLE
G104 5-52 SM
3411 004 Max. Print: [Cl] *EGB
Maximum: For low image coverage, more
sheets can be printed. This sets the
maximum that can be printed after toner end
is detected.
[0 to 750 / 0 / 1/step] DFU
3411 005 Pixel: [K] *EGB
3411 006 Pixel: [Cl] *EGB
Adjusts the number of sheets (A4), which the
pixel area is converted into for the toner end
after detecting the toner near end.
[0 to 100 / 0 / 1 sheet/step]
3501 [Process Cont.] Process Control
3501 001 ON/ OFF *EGB Sets the method of the process control.
[0 to 3 / 0 / 1/step]
0: Auto, 1: Fixed
2: Auto + LS, 3: Auto (Table fixed)
Do not use settings 2 and 3.
3511 [Pntr. Display] Process Control Table Display ([Color])
3511 001 [K] *EGB
3511 002 [M] *EGB
3511 003 [C] *EGB
3511 004 [Y] *EGB
Displays the current process control table for
each mode.
[1 to 30 / 15 / 1/step]
3531 [M/A Target] ([Color])
3531 001 [K] *EGB
Adjusts the maximum toner target M/A for
each mode.
[0.000 to 1.000 / 0.53 / 0.001 mg/step]
3531 002 [M] *EGB
3531 003 [C] *EGB
3531 004 [Y] *EGB
[0.000 to 1.000 / 0.500 / 0.001 mg/step]
3541 [TD Setting] Toner Density Adjustment Setting
3541 001 *EGB [ 0 or 1 / 0 / -]
0: On, 1: Off
3551 [PC SelfChk] Process Control Self-check
3551 001 Job End 1: [K] *EGB
3551 002 Job End 1: [Cl] *EGB
At the end of a job, process control is done
after the interval of time that is set with SP
3555 001, if this number of pages was
printed after the previous process control.
[0 to 2000 / 210 / 1 page/step]
3551 003 Job End 2: [K] *EGB
3551 004 Job End 2: [Cl] *EGB
At the end of a job, process control is done
immediately, if this number of pages was
printed after the previous process control.
[0 to 2000 / 300 / 1 page/step]
3551 005 Job End 3: [K] *EGB
In the middle of a job, printing stops and
To Next Page
Loading...
