Ricoh G104 - Page 199

ENGINE SERVICE MODE
SM 5-83 G104
Service
Tables
8061 [T: 1-0-07] *CTL
8064 [P: 1-0-07] *CTL
8067 [O: 1-0-07] *CTL
Finish, post-print processing jobs
The number of times the application program uses the finisher
[0~9999999/ 0 / 1]
001 Sort
The number of times the application program starts
the sort mode
002 Stack
The number of times the application program starts
the tack mode
003 Staple
The number of times the application program starts
the staple mode
004 Booklet
The number of times the application program starts
the booklet mode
NOTE: The counter of the staple mode (003) can also
increase.
005 Z-Fold
The number of times the application program starts
the Z-fold mode
NOTE: The booklet mode is not included.
006 Punch
The number of times the application program starts
the punch mode
NOTE: The counter of the printer application program
(P:) can also increase.
007 Other (Reserved)
8071 [T: 1-0-08] *CTL
8074 [P: 1-0-08] *CTL
8077 [O: 1-0-08] *CTL
Jobs/ Pages
The number of jobs that try to output a specific number of pages
[0~9999999/ 0 / 1]
-001 1 Page -008 21~50 Pages
-002 2 Pages -009 51~100 Pages
-003 3 Pages -010 101~300 Pages
-004 4 Pages -011 301~500 Pages
-005 5 Pages -012 501~700 Pages
-006 6~10 Pages -013 701~1000 Pages
-007 11~20 Pages -014 1001~ Pages
• The jobs interrupted by paper jams or some other errors are also counted.
• If a job is suspended and restarted later, the job is seen as one job.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA