PROCESS CONTROL
G104 6-10 SM
2. Interval: Job End
At the end of a job, process control is done after the interval of time that is set
with SP 3555 001, if more than 210 prints (default) were made after the
previous process control (this number can be changed with SP3551-001 and -
002).
At the end of a job, process control is done immediately, if more than 300
(default) prints were made after the previous process control (this number can
be changed with SP3551-003 and -004).
The default setting of SP 3555 001 is 0. Because of this, there is no difference
between these two processes, and the 300-print setting is not used.
After process control is done (except for forced process control), the counters
are reset to “0.”
3. Interval: Interrupt (default: 500)
If the machine makes a sequence of 500 or more color prints in the same job,
printing stops and process control is done. After it is completed, the machine
continues to make prints. The default value of 500 can be adjusted with
SP3551-005 to -006
4. Non-use Time (6 hours)
This starts before the next print job if the machine has no job for 6 hours. If the
non-use time process control is done (N) times after the user turns on the
power, it will not be done. N is adjusted with SP3558.
5. Installation
This starts only when this machine turns on at first installation. The machine
does this if SP5-950-001 is set to 1 (set at the factory).
6. After Toner End Recovery
This starts after recovery from a toner end condition.
7. After Developer Initialization
This starts after a developer initialization is done. Developer initialization occurs
automatically after a new PCU is installed.
8. After Transfer Belt Unit Initialization
This starts after a transfer belt unit initialization is done. Transfer belt unit
initialization occurs automatically after a new transfer belt unit is installed.
9. Forced
This is done when SP3-820-001 is used.
To Next Page
Loading...
