Service Mode Table
SM 5-187 G133
Service
Tables
While making prints with low coverage, the developer is agitated with less
toner consumption and the toner carrier attraction tends to increase. This may
cause low image density or poor transfer (white dots). To prevent this, the
coagulated toner or overcharged toner has to be consumed by performing the
refresh mode.
001 Distance: DevMt: K *ENG
002 Distance: DevMt: M *ENG
003 Distance: DevMt: C *ENG
004 Distance: DevMt: Y *ENG
[0 to 1000 / 0 / 1 m/step]
005 Threshold: Distance *ENG
[0 to 1000 / 1 / 1 m/step]
006 Pixel Coverage: Bk *ENG
007 Pixel Coverage: M *ENG
008 Pixel Coverage: C *ENG
009 Pixel Coverage: Y *ENG
[0 to 65535 / 0 / 1 cm
2
/step]
010 Required Area: Bk *ENG
011 Required Area: M *ENG
012 Required Area: C *ENG
013 Required Area: Y *ENG
[0 to 65535 / 0 / 1 cm
2
/step]
014 Refresh Threshold: Bk *ENG
015 Refresh Threshold: M *ENG
016 Refresh Threshold: C *ENG
017 Refresh Threshold: Y *ENG
[0 to 255 / 34 / 1 cm
2
/m/step]
018 Pattern Generation Number: Bk *ENG
019 Pattern Generation Number: M *ENG
020 Pattern Generation Number: C *ENG
[0 to 255 / 0 / 1 time/step]
To Next Page
Loading...
