Ricoh IM CW2200

Message Cause Solution and reference
"Exceeded max. email
size. Sending email has
been cancelled. Contact
the administrator about
max. email size."
The file size per page
has exceeded the
maximum e-mail size
specified in [Maximum
Email Size].
• Specify a lower value in [Send Settings]
[Resolution], or select a smaller paper
size in [Send Settings] [Scan Ratio]
[Specify Size].
• You can change the [Maximum Email
Size] setting on [Settings] [Scanner
Settings] [Sending Settings] [Email
(Size)]. To divide an e-mail that exceeds
the maximum size, specify [Yes (per
Page)] or [Yes (per Max. Size)] in [Divide
& Send Email].
"Exceeded max. number
of alphanumeric
characters."
The number of entered
characters has
exceeded the maximum.
Check the maximum number of characters.
page 277 "The Setting Values of the
Transmission Function"
"Failed to connect to the
destination. Please
contact the administrator
to check the following.
*The correct root
certificate is registered to
this machine and
destination. *The root
certificate check function
is not enabled by
mistake."
Email was sent to the
destination without an
installed certificate of
the destination server
when "Root Certificate
Check" was set to
[Active].
Contact your network administrator. Network
administrator should install the root certificate
of the destination server in Web Image
Monitor if required, or set "Root Certificate
Check" to [Inactive].
See "Controlling Access to Untrusted Websites
from the Control Panel", User Guide (Full
Version).
"Insufficient memory in
the memory storage
device."
There is no free space
available on the SD
card or USB flash
memory device, or the
file could not be saved
due to insufficient space
on the media.
Change the external media. When scanning
an original in the divide-document or single-
page mode, the saved data may not contain
all pages in the original.
When a Message Appears While Using the Scanner Function
225