8. Press [Exit].
If Auto Adjust Head Position has failed, perform Manual Adjust Head Position.
9. Press [Home] ( ) after completing the operation.
• Auto Adjust Head Position cannot be performed when "Paper Type" is set to [Film: Matte]. Perform
Manual Adjust Head Position.
• Auto Adjust Head Position cannot be performed for the paper bypass location. Perform Manual
Adjust Head Position.
• For details about Prevent Paper Abrasion mode, see page 247 "Checking Whether the Print-heads
Scratch the Paper".
• For details about Manual Adjust Head Position, see page 254 "Manual Adjust Head Position".
Manual Adjust Head Position
If auto adjust head position has failed, or if you feel the print quality is not improved by auto adjustment,
adjust the head position manually.
To check the print results of the test pattern, proceed to Step 8.
• Printing the test pattern consumes ink. Perform this function only when necessary.
• Perform no other operations while the test pattern is printing.
• An error will occur and test patterns will not print if:
• There is a misfeed.
• One of the machine's covers is open.
• The machine is performing maintenance operations.
• The machine has run out of ink.
• The machine has run out of paper.
• The ink collector unit is full.
1. Press [Settings] on the Home screen.
2. Press [Maintenance] [Manual Adjust Head Position].
3. Select the paper input location for the head position you want to adjust.
9. Troubleshooting
254
To Next Page
Loading...
