UDP listen port PORT Sets the port on which the indicator listens for commands. Replies are
sent to the last IP:port that a command was received from. On non-
network ports (AUTO.LO, etc), the receving end should send an empty
UDP packet to the indicator to initiate sending. Selectable from 0 to
65535. Default is 0 (disabled).
Network options NET.OPT Options for serial networking
Serial Address ADDRESS The serial network address. Selectable from 0 to 31. Default: 31
Custom
Identifier
ID The custom unit identifier returned by the IDN command parameter 1
(see Section 21.3.24). Maximum of 15 characters. Default: C500
Auto Transmit
Options
AUT.OPT This is a list of all items concerned with automatic and single serial
transmission of weight data.
Auto output TYPE The auto transmit format (see Section 8). Options are:
AUTO.A: Format A (default)
AUTO.B: Format B
AUTO.C: Format C
AUTO.D: Format D
CUSTOM: Custom format as set in SERIAL:AUT.OPT:AUT.FMT
AUTO.F: Format F
Auto Output
Source
SOURCE The weight source for the output data. Options are:
DISP(def): Displayed weight
GROSS: Gross weight
NET: Net weight
TOTAL: Total weight
Custom format AUT.FMT Custom format (see Section 8.2.6 for more information).
Start Character ST.CHR Sets the ASCII character sent at the start of the automatic message. If
set to 0, no character is sent. Default: 2 (STX)
End Character 1 END.CH1 Sets the 1st of 2 ASCII characters sent at the end of the automatic
message. If set to 0, no character is sent. Default: 3 (ETX)
End Character 2 END.CH2 Sets the 2nd of 2 ASCII characters sent at the end of the automatic
message. If set to 0, no character is sent. Default: 0 (none)
Printing Options PRN.OPT This is a list of all items concerned with printing.
Printout Type PRNT.TP Set the printout type (see Section 9.1). Options are:
SINGLE(def): Print a single line with no extra line feed
DOUBLE: Print single line output but double spaced
TICKET: Print full weight ticket
A.SING: Auto print a single line with no extra line feed
A.DOUB: Auto print single line output but double spaced
A.TICK: Auto print full weight ticket
TOTAL: Totalising printer mode
A.TOTAL: Automatic Totalising printer mode
Ticket Header HEADER Ticket header (see Section 9.2).
Ticket Format TIC.FMT Ticket format (see Section 9.3).
Space Columns
and rows for
print
SPACE Position of the printout. The 1st parameter sets the horizontal spac-
ing. The 2nd parameter sets the vertical spacing (see Section 21.3.40).
Default: 00.00
Print Interlock I.LOCK Print interlock type. Options are:
NONE: No interlock (default)
MOTION: Motion must occur between printouts
RET.Z: Scale must return to the zero band between printouts
Modbus Options MOD.OPT This is a list of all items concerned with Modbus.
25 C500-600-2.0.3
To Next Page
Loading...
Need help?
General
