Rinstrum C530 - Page 94

Name Address Type R W Description
Setpoint 2 Reset A431
H
uint8 A A Setpoint 2 rest:
0 is none
1 is reset A
2 is reset B.
Setpoint 3 type A441
H
uint8 A A Set setpoint 3 type:
0 is off
1 is on
2 is over
3 is under
4 is centre of zero
5 is zero band
6 is net
7 is motion
8 is error
9 is buzzer
10 is weigh out
11 is weigh in.
Setpoint 3 lock A442
H
uint8 A A Set setpoint 3 lock:
0 is off
1 is on.
Setpoint 3 logic A443
H
uint8 A A Set setpoint 3 logic:
0 is high
1 is low.
Setpoint 3 alarm A444
H
uint8 A A Set setpoint 3 alarm:
0 is none
1 is single beep
2 is double beep
3 is continuous beeping
4 is flash the display.
Setpoint 3 source A446
H
uint8 A A Set setpoint 3 source:
0 is gross weight
1 is net weight.
Setpoint 3 Target A448
H
int32 A A Set setpoint 3 target.
Setpoint 3 Hysteresis A449
H
int32 A A Set setpoint 3 hysteresis.
Setpoint 3 in flight A44A
H
int32 A A Set setpoint 3 in flight.
Setpoint 3 Timing A450
H
uint8 A A Setpoint 3 timing:
0 is level
1 is edge
2 is latch
3 is pulse.
Setpoint 3 Reset A451
H
uint8 A A Setpoint 3 rest:
0 is none
1 is reset A
2 is reset B.
89 C500-600-2.0.3