Risco RisControl User Manual

53
3. Select the required Partitions and then click the “Arm” button.
Note: You can check/uncheck the ‘All Partitions” box to select/deselect all
Partitions by a single action.
The Group icon status indications (see above) also apply to the Groups Partitions
screen.
Note: If after clicking the “Arm” button the selected Groups are not armed due to
Not Ready state, a new screen will appear indicating the Groups that are
Not Ready and the causes of the Not Ready states.
Detectors
The Security→Detectors screen lists all the devices that are part of the partitions
that the user has permission to view.
1. Click the Detectors tab; the following screen is displayed.
Figure 49: Security – Devices Screen
There are three detector icon status indications, as follows:
• Green: Disarmed
• Orange: Part Arm
• Red: Full Arm
2. Click any of the detectors to either bypass the detector or mute its “Presence
Notification”, as shown below:

Risco RisControl Specifications

General

Brand	Risco
Model	RisControl
Category	Control Panel
Language	English