86
3. Contact the installer and inform him of the Anti-Code.
4. Enter the code in the “Anti-Code” field and then click the “OK” button to
complete the procedure.
Monitoring Station
Click the “TEST” button to send a test message to the monitoring station, according
to requirements for EN50131 standards.
Sounds
The user can change the sound settings of the RisControl.
The user can also individually turn on/off the following sounds:
• Buzzer
• Key tones
• Chime
1. Click “Sounds” in the Settings Menu; the following screen is displayed.
Figure 89: Sound Settings Screen
2. Drag to set the volume of the RisControl speaker (also increases/decreases all
the sounds that are generated by the RisControl).
To Next Page
Loading...
