Risco RisControl - Step 3: Setting the Wi-Fi Connection (Optional)

13
Note: The RisControl will not communicate by BUS until prompted by the
panel following the "Scan for devices" procedure that the installer initiates
from the panel.
2. Following address setup of the RisControl, click “NEXT”.
Note: The setup procedure will continue in parallel with the time it takes for
the RisControl to be added to the Security System (that has not yet
“discovered” the other RisControl on the bus).
Figure 3: Bus Address Setting
Step 3: Setting the Wi-Fi Connection (optional)
The RisControl can be connected to the RISCO Cloud via Wi-Fi.
Note: The connection to the Wi-Fi can also be performed by the end-user at a later
time.
1. From the screen that appears, select a Wi-Fi network from the list.
Note: If RISCO Cloud connection is not required, click the "Skip" button.