Basic Operations
Printing from a Computer Data [Direct Print] [USB Job List]
49
Printing USB Data [USB Job List]
Even if the computer and machine are not connected by cable, you can print original data via a USB Flash Drive.
It is useful when the computer and printer are placed in different places.
Note:
• When “User Management” is set by the administrator, the users will be asked to identify themselves during oper-
ations. For details, see )p.43.
1
Connect the USB Flash Drive to the
computer.
Note:
• If the Recognition and Identification System
("Recognized by") is set to "USB Flash Drive" in
the "User Management", it is also convenient
for you to use the registered USB Flash Drive
for outputting data.
2
Set printing options from your com-
puter screen.
Use the USB flash-via-printer driver.
Note:
• Make sure to remove the checkmark from the
“Collate” option in the Print dialog box.
3
Click [OK] in the print dialog box.
The data created on the computer is stored in the
USB Flash Drive.
4
Make sure the machine is ON.
Check the Control Panel.
Note:
• When the power is OFF, both the Display and
the key are off. Turn the power ON.
)p.32
• If the key is lit, the machine is in the Energy
Saving mode. Press the key to cancel the
Energy Saving mode.
5
Check for printing paper.
Make sure paper is loaded.
To load or to change paper, see following page.
)p.32
After replacing with paper of a different size,
adjust the position of the Receiving Tray Paper
Guides and Paper Stopper.
)p.35
6
Connect the USB Flash Drive that
contains the original data to print to
the USB slot.
If you use an unregistered USB Flash Drive for
outputting data, skip to step 9.
Important!:
• Do not remove the USB Flash Drive until the
printing is completed.
It might cause loss of data and settings or dam-
age to the USB Flash Drive.
REG-ML_EN.book Page 49 Wednesday, September 21, 2011 5:19 PM
To Next Page
