Functions for Master-Making
Cutting the Top Margin of the Original and Printing [Top Margin]
83
Cutting the Top Margin of the Original and
Printing
[Top Margin]
You can cut the top portion of the margin to between 0 to 99 mm (0" to 3
7
/
8
") and make a master.
This feature enables you to skip the registration marks
*
on the original and print on the finish-sized paper without any
of these marks.
A margin on the paper periphery is required even if you use “Top Margin” function.
)p.18
* About the Registration Mark
In the field of commercial printing, it is normal to print on paper that is larger than the finished size and then cut down
to the finished size afterwards. The symbol that indicates the position to cut in this event is known as the registration
mark.
Important!:
• When you are setting the “Size”, magnify / reduce using the area that skips the set value.
• Do not use “Auto Reproduction Size”.
• This function cannot be used with “Multi-Up Print” and “2 Up”.
1
Place an original.
Place the original face down on the Glass Platen.
Align center on the top edge, and close Platen
Cover.
2
Touch [Functions] on the Master
Making Basic Screen.
3
Touch [Top Margin].
4
Touch [ON].
A4
Black
Page(A4)
Basic Selections Functions Admin.
Contrast Size Paper
Idle Info
Ready to Make Master
Reserva-
tion
Multi-Up
Print
Editor
Dot
Process
Line
Auto
Basic Selections Functions Admin.
Ready to Make Master
P
.
Program
Meter Display
1/4
Job Memory
Dot Process
Top Margin
Book Shadow
2 Up
Multi-Up Print
Ready to Make Master
Basic Selections Functions Admin.
2/4
P
.
Cancel OK
Top Margin
(Numeric keypad is available for input)
The top margin of
originals can be cut
by a specified range
OFF
ON
REG-ML_EN.book Page 83 Wednesday, September 21, 2011 5:19 PM
To Next Page
Loading...
