Rlide R2 Series - Page 117

115
c.
Use [▲]/[▼] to move to items that need
to change be changed.
[▲]/[▼]
<Angle>
VA0:
Zenith
Min
Ang:
5”
HA:
Azimuth
d.
Press [ ]/[ ] to change the settings, and
press [ENT].
[ ]/[ ]
<Angle>
VA0:
Zenith
Min
Ang:
5”
HA:
0 to BS
e.
If any of these settings are changed while
a job is open, a confirmation screen
appears, asking you whether to close the
current job. ※1)
Press [Abrt] to use the settings in current
job and abort the change.
Press [OK] to close the job in measure or
record function, program will ask whether
to select or create a job.
<Angle>
Job set
to be changed
* Close current job?
Abrt
OK
f.
The display returns to Settings menu.
Settings
1.Angle
6.So
2.Dist
7.Unit
3.XYZ
8.Record
4.Power
9.Other
5.Comm
※1) About the setting of twelve items, see“11.1.2 Creating a New Job”.
In the following form, the items in can’t be changed once a job is created.
Item
options
Angle
VA0: Zenith/Vertical/Vert± 90
Min. Ang: 1″/5″/10″
HA: Azimuth/0 to BS
When this field is set to Azimuth, the horizontal angle (HA) that is displayed and recorded
is in Azimuth value.
When this field is set to 0 to BS, HA is in HA zero to BS value.
Scale: Numeric value between 0.990000 and 1.010000
T-P crn: ON/OFF