g.
If the third line “L/R” does not display 0
m, ask the rodman to adjust the target
position.
: Rodman moves to his left side.
: Rodman moves to his right side.
h.
When both R/L and IN/OUT display 0m,
it indicates the prism is on the stakeout
point.
i.
After staking out, your can press [ENT]
to record the stakeout point. PT defaults
to the last recorded PT+1, you can input
code if necessary. Press [ENT] to record
the point.
j.
After recording the point, the display
returns to the SO screen. Press
[Prev]/[Next], or [▲]/[▼] to stake out
other divided points. ※2)，※3)
※1) Use up or down arrowhead to change the guide point.
※2) Prev/[▼]: to the last stakeout point Next/[▲]: to the next stakeout point
※3) You can calculate and guide up to double the number of the stakes.
5.4 REFLINE STAKEOUT
This function allows you to stake out a point based on the Sta, O/S, and dZ to a specified line.
a.
In [SO] menu press [4] to enter to
Ref.Line stakeout function.
To Next Page
Loading...